What to do if washer is off balance?

If you cannot see a problem, you may need to remove the front or top panel and the agitator. Remove the offending item and clean out any debris. Replace the agitator and panel before running the machine again. Top loading, direct drive, washers will go off balance for several reasons.

How to Repair a Washing Machine that Is Unbalanced

  1. Step 1 – Check Level. Place a straight level on top of the washer to see how much off balance the washing machine is.
  2. Step 2 – Level with Legs. Most washing machines come with adjustable legs in the front and the back.
  3. Step 3 – Tighten Drum.
  4. Step 4 – Keep Large Items Out.

Subsequently, question is, why is my washing machine shaking violently? Possible Cause: Unbalanced Washer The spin speed of an average washing machine is between 600 – 1400RPM. If the washing machine is not balanced, it may shake violently during the spin cycle, causing water to spill on the floor. A washing machine imbalance can be caused by a unit that does not sit level to the ground.

Also know, how do you know if your washer is off balance?

Check that the machine is level across the front, back and sides. A machine that is not level will rock during the spin cycle and cause the machine to be off balance. All four legs should be in firm contact with a solid floor. A carpeted surface can throw this balance off.

What causes a washer to be unbalanced?

All front-load washing machines have shock absorbers that are used to dampen the tub movement in the spin cycle. When shock absorbers weaken or become damaged, unbalanced loads will cause the washer to shake or move and the machine will often make a loud banging sound during the spin cycle.

Why is my washing machine making a banging noise when spinning?

The most common reason for a noisy washing machine is that you’ve overloaded the tub or that the clothes in the tub are unevenly distributed. This causes the inner tub of the washing machine to spin unevenly, often hitting against the outer tub and creating the banging noise.

What causes bearings to go in washing machine?

Both front and top load washers use bearings that will eventually become defective with use. Over time, water seeps through the seal and rusts the bearings. Rusted bearings are the main cause of the loud noise that you hear when the washer is spinning.

Should a washing machine drum moves back and forth?

Grinding noise from the drum during the wash and spin cycles usually suggest that the drum bearings have worn. To check, turn the drum back and forth; movement should be smooth and easy with very little resistance or noise.

How do you reset a Samsung washer?

Push the door closed firmly and press “Power” to turn off the washing machine. Disconnect power to the unit for 10 seconds and then restore power and press “Power” to reset.

How do I troubleshoot my Samsung front load washer?

SAMSUNG WASHER FIX/SOLUTION: Check the fuse or reset the circuit breaker. Straighten the drain hoses. Eliminate kinked hoses. If there is a drain restriction, troubleshoot it. Close the door and press the Start/Pause button. For your safety, your washer will not tumble or spin unless the door is closed.